WIP: Ferrari F310b, Francorchamps 1997
Just a little update. I have found the yellow goodyears for front and back wing. They were kindly given to me by a good friend. The frontwing is yet to become clearcoated and polished. I've started to decal the hole car, but there is a problem with rear side bodywork. I have to respray them because the paintwork came of when polishing some dust . Anyway, this is the nosecone with the frontwing.
After looking at the bardgeboards I wasn't happy with them. Since I couldn't manage to secure the outdated set from ST27 in wich there were a new set of bardgeboards, I decided to make them myself. So I started working with some K&S 250 brass (.005x4x10). After some bending I could solder the topside to the bardgeboard. It came out ok .
Untill next time, ciao
Eric
After looking at the bardgeboards I wasn't happy with them. Since I couldn't manage to secure the outdated set from ST27 in wich there were a new set of bardgeboards, I decided to make them myself. So I started working with some K&S 250 brass (.005x4x10). After some bending I could solder the topside to the bardgeboard. It came out ok .
Untill next time, ciao
Eric
Thanks guys for all your kind comments. Let me tell you that your comments are an inspiration for me and keep me going. At the moment I have little time to spent on the model. I have to keep it up as october is closing in very fast now. I must finish it by then. So... next week I'm planning to spent much time to get the Ferrari decalled and clear coated and after that it's engine time . I'll keep you all posted.
Eric
Eric
Re: WIP: Ferrari F310b, Francorchamps 1997
After 4 months I'm ready to restart the building of the F310B. As you have noticed I didn't make the deadline for the modelshow, so perhaps I will enter it next year. This WIP is BACK!!!
-
- FOTA Chairman
- Posts: 2605
- Joined: Wed Aug 07, 2002 4:49 am
- Favorite F1 Team or Driver: Schumacher
- Location: Cologne/Germany
- Contact:
- Status: Offline
Re: WIP: Ferrari F310b, Francorchamps 1997
very very nice....for the CF templates I would suggest taping them of the backside of the decal...ok they are sideways but 99% of the parts are the same left and right, so you could switcht them
???...got it
daniel
-germany-
???...got it
daniel
-germany-
-
- Top Designer
- Posts: 757
- Joined: Sat Nov 27, 2004 7:20 pm
- Location: Brisbane, Australia
- Status: Offline
Re: WIP: Ferrari F310b, Francorchamps 1997
Great work so far!
What brand of CF decal was it that you used on the front wing?
What brand of CF decal was it that you used on the front wing?