PE set for 1/20 Tamiya McLaren M23?
PE set for 1/20 Tamiya McLaren M23?
I'm just gathering extras to build the Tamiya 1/20 McLaren M23 (latest version) in Hunt 1976 flavour,my question is,what PE set do I go for/what's the best,the Tamiya factory version or the Studio27 version?............any help or advice welcome,thanks
-
- FOTA Chairman
- Posts: 2477
- Joined: Thu Mar 17, 2005 11:32 am
- Location: Kӧln, Germany
- Status: Offline
Re: PE set for 1/20 Tamiya McLaren M23?
I used the Tamiya set. Not too bad= - radiator faces, wing end plates and mounting plates, but one of Tamiya's paper-based seatbelt sets.
-
- FOTA Chairman
- Posts: 2477
- Joined: Thu Mar 17, 2005 11:32 am
- Location: Kӧln, Germany
- Status: Offline
Re: PE set for 1/20 Tamiya McLaren M23?
I used the Tamiya set. Not too bad - radiator faces, wing end plates and mounting plates, but one of Tamiya's paper-based seatbelt sets.
<<D'Oh double post!>>
<<D'Oh double post!>>
Last edited by generationx on Sun Sep 29, 2013 4:29 am, edited 1 time in total.
-
- FOTA Chairman
- Posts: 3178
- Joined: Sat May 14, 2005 8:50 am
- Your Name: Chris Bartholomew
- Favorite F1 Team or Driver: Forza Ferrari!!!
- Location: Michigan, USA
- Status: Offline
Re: PE set for 1/20 Tamiya McLaren M23?
I used the S27 set, and it worked fine for me. Also primarily needed for wing end-plates,rear wing mounts and heat-exchanger surfaces. I used seat-belts from a different seat-belt set, just can't remember from where, though . I think either set will work for your purposes.
Cheers,
Chris
Cheers,
Chris
Re: PE set for 1/20 Tamiya McLaren M23?
Thanks for the top advice guys,this is well appreciated