Page 1 of 5
Protar Ferrari 156/85
Posted: Thu Jan 06, 2022 6:40 am
by Shunter
Re: Protar Ferrari 156/85
Posted: Thu Jan 06, 2022 7:47 am
by JamesB
Nice you give it a chance!!
Far cry from being a bad kit. Shapes are qite accurate! It´ll improve with good decals
Re: Protar Ferrari 156/85
Posted: Thu Jan 06, 2022 10:12 am
by steveracer
nice to revive an old "primer bomb" kit. I will watch this come to life! Keep up the good work, it will be a nice piece on the shelf.
Re: Protar Ferrari 156/85
Posted: Thu Jan 06, 2022 1:19 pm
by CK
Nice progress so far.
The fit of the engine cover is not good on my kit. Also, the front wheel has the wrong diameter. It should be 13", the same as the rear rims.
Anyway, the finish model should look good.
Re: Protar Ferrari 156/85
Posted: Thu Jan 06, 2022 1:54 pm
by Noddy
There is a p/e stencil in the aftermarket for this model to spray the logo onto the radiators. Pretty sure there are replacement decals too if you need them.
Re: Protar Ferrari 156/85
Posted: Fri Jan 07, 2022 9:05 am
by Jeff
Great save Shayne! Will look great next to your F2003
Re: Protar Ferrari 156/85
Posted: Sat Jan 08, 2022 3:06 am
by Shunter
Jeff wrote: ↑Fri Jan 07, 2022 9:05 am
Great save Shayne! Will look great next to your F2003
Thank you all…
Great memory Jeff, I hope it turns out all OK…we shall see
Re: Protar Ferrari 156/85
Posted: Sat Jan 08, 2022 3:42 am
by Tiffoc
Hi Shayne, it's beginning to look a lot like... no not Christmas
... a Ferrari 156/85...
I love Protar kits, I've been asked many times, "But why???"... My answer is always the
same, because they're not a give me build, you have to work hard to get them to look
awesome. You have to take your skills and ingenuity to exceptional lengths. You've got
a bonus, making someone else's build start reach your standards, twice the fun!!!
Stick with it doing a grand job, good luck
Re: Protar Ferrari 156/85
Posted: Sat Jan 08, 2022 4:21 am
by JamesB
It´ll be great, Shayne. I have some suggestions...
the small plate where the flap of front wing can swing on, is faked in the kit as plastic protruding a hole in the red plastic. I suggest putting a real thin plate (even if a tad bigger) so it really overlaps the nose cone surface.
Then I´d also replace the front and rear wing endplates. Protar´s parts are quite thick.
Also be sure to check that overall wings widths are 41.6 62.5 mm respectively, makes not always respect the FIA rule book!
Re: Protar Ferrari 156/85
Posted: Sat Jan 08, 2022 4:34 am
by Shunter
I have started the decal work. I went with the Shunko sheet as it has all the markings for the incorrect and inappropriate sponsors, so far so good. I did a test with the Shunko logo to start and it shattered on me, this was a little concerning, but the others have gone well so far.
65429F53-5088-4529-93B8-567974D7A84C
5D968A38-73F6-409F-B9D6-C9C023C7FD92